2.5D smart objects using thermoplastic stretchable interconnects

This contribution describes the technology used to produce thermoplastically deformable electronics, based on flexible circuit board technology, to achieve low-cost 2.5D free-form rigid smart objects. These one-time deformable circuits employ a modified version of the previously developed meander-based "polymer-last" technology for dynamically stretchable elastic circuits. This is readily achieved by substituting the dynamically stretchable elastomeric materials (e.g. silicone) with thermoplastic polymers (e.g. polycarbonate). Afterwards the circuit is given its final form using widely available thermoforming techniques, such as vacuum forming, where the material is heated above its glass transition temperature and drawn against a forming tool by a strong vacuum. After cooling down the thermoplastic retains its shape without inducing large internal stresses. The presented method allows for the production of these circuits on a flat substrate, using standard printed circuit board production equipment, with deformation only taking place afterwards; eliminating the need for large investments and reducing the cost of fabrication. Potential advantages over competitive methods are reductions in weight and material usage, decrease of mechanical complexity; lower tooling cost, increased resilience, and a higher degree of manufacturer independence due to adhering to standard industrial practices. This is realized by starting production from a flexible circuit board, manufactured by an industrial supplier using polyimide flexible copper clad laminate, which is attached to a temporary reusable carrier board through means of a silicone based high-temperature pressure sensitive adhesive. Through selective laser structuring the meander and island outlines of the flexible circuit are defined, without causing damage to the carrier board or pressure sensitive adhesive. After removing the residual material the circuit is assembled using high-temperature lead-free solder, made possible by the temporary carrier keeping the circuit in place at these elevated temperatures. The circuit is then transferred into a thermoplastic laminate, which is deformed into its final shape. After demonstrating the need for stretchable electronics for this application, this contribution describes the method used to design, fabricate, and test the first one-time deformable circuits manufactured using the presented technology. Using the initial set of observations a series of preliminary design rules is established, both for the circuit and choice of materials. The feasibility of this manufacturing method was then demonstrated through a small scale production run using lab scale equipment, where a large quantity of high power LEDs was integrated into a one-time deformable device made out of polystyrene and thermoplastic polyurethane. These devices were then tested by exposing them to real world conditions for several days.

from #MedicinebyAlexandrosSfakianakis via xlomafota13 on Inoreader http://ift.tt/1I3iEAs
via IFTTT